My server had 2 x 60gb Seagate IDE drives in a software RAID-1 array.
For those of you who don’t know, this means that although I had two 60gb drives in the server, it only looked like I had one, because I’d set it up so that Windows kept a “mirror” of the drive. That meant that if one drive failed, my machine would still work ok because the “mirrored” copy would still be available.
One of the drives recently started showing errors, so I decided to replace it.
Although 60gb drives are still available, I decided to replace the array with two 160GB drives to give me a bit more space.
The big question was, how to replace the drives without taking my server offline for too long?
One alternative would be to break the mirror (remove the faulty drive from the machine) and replace it with the new 160GB drive, then add that 160GB drive to the mirror. Althoug I wasn’t 100% certain, I thought that if I did this, the 160GB drive would only use 60GB of the available space, and I’d be wasting most of it. Despite this, the advantage would be that the machine would only be offline just for the time it took to replace the drive and turn it back on again.
Instead of this approach, I decided to add one of the 160gb drives to the machine as a 3rd disk drive. I would then use Norton Ghost to copy the contents of the mirrored volume onto the new drive. The disadvantage of this approach is that Norton Ghost requires the machine to be offline while it runs in DOS mode to copy the entire contents of the drive, ensuring that nothing gets changed inadvertently while copying from one drive to another.
For some reason I cannot fathom, 10 minutes after starting the Ghost, the screen on the server went blank, and the server died. Initially I thought it was just some sort of lowlevel screen saver in the video card (optimistic, aren’t I?) so I left the machine for a couple of hours, hoping that ghost would finish.
Eventually, after trying the same process several times, I came to the conclusion that ghosting a mirrored volume just wasn’t going to work. I thought perhaps it was because my power supply couldn’t cope with 3 drives, tape drive and DVD drive and so disconnected the DVD and tape. This still didn’t fix the problem, so all I can suggest is that Ghost doesn’t like copying mirrors.
In the end, I read the instructions on the label of the new disk drive, downloaded a utlility from http://www.seagate.com/support called “DiscWizard for Windows” and ran it.
It’s great!!! It found my new drive, formatted and partitioned it for me, then asked me if I wanted to replace an existing bootable drive. I said yes, it copied all the files, then gave me a printout telling me what jumpers to change on each of the drives, and whereabouts on the IDE cable to put the new drive. All with friendly illustrations.
AND it did all the copying while the server was still online.
AND (best of all) it worked!
The added bonus is that DiscWizard is free. It comes with all Seagate drives.
So the moral of the story is that I was trying to be too smart. In this situation, if I had just RTFM (read the fine manual) I would have saved myself about 12 hours of frustrating heartache.
Today I’ve got two 160gb drives in a mirrored array, and feel very relieved that it’s all working again. I’ll know next time how to swap my disks over with the minimum amount of messing around.